P2M FT86 REAR UPPER CONTROL ARMS (NEGATIVE CAMBER)

Description

CAMBER ADJUSTMENT:

– By default can go up to -6 negative camber.

– The arm is setup for NEGATIVE CAMBER adjustment ONLY. Please DO NOT run stock camber (0 to -1 deg) with this arm as it can be overly extended.

– It is RECOMMENDED to run between -3 to -6 deg of camber with this arm for preferred setting.

– By removing the first jam nut (nut in front of the turnbuckle) will gain additional -2 deg (for approximate total -8 deg camber)

– By removing the last jam nut (nut in the BACK of the turnbuckle) will gain additional -3 deg (for approximate total -9 deg camber)

– By removing BOTH jam nuts will achieve approximate -10 to -11 deg of camber

** DISCLAIMER: FOR ANYONE REMOVING THE JAM NUTS TO ACHIEVE NEGATIVE CAMBER PLEASE MAKE SURE THE ARMS MUST BE LOCKED INTO THE SHORTEST POSITION. DO NOT EXTEND THE ARMS WITHOUT JAM NUTS IN PLACE.